 |
|
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!
|
|
| FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
| Line connection only to outside of shape? | Thread Tools | Search this Thread | Display Modes |
|
Member
2006-09-15, 03:40 AM
Hmm. If I try to connect two magnets on the same shape, I'm forced to have them connect to the "outside". This makes some figures harder to do than I would like. Might be nice to have an option for "allow connections through inside of shape" or so ...
Post 1
|
|
Member
2007-08-08, 09:55 AM
I just ran across the problem. I wanted to place dividers inside a rounded square vertical box to divide text. No can do with the line tool.
Has this changed?
Post 2
|
|
Omni
2007-08-08, 10:28 AM
If you place magnets on the shape, you can connect a line directly to the magnets and get the desired result:
__________________
"Vroom! Vroom!!"
Post 3
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Connection Line Help Needed | Roggie Rog | OmniGraffle General | 1 | 2012-05-07 05:10 PM |
| Auto Rearrange Line When There Is A Shape in The Way | juminoz | OmniGraffle General | 2 | 2012-01-20 06:21 AM |
| How to prevent a line from being routed over a shape? | namtastic | OmniGraffle General | 0 | 2009-11-17 02:25 PM |
| Handle to move connection line | Druka White | OmniGraffle General | 2 | 2008-11-02 11:23 PM |
| Line Connection Help | fausty | OmniGraffle General | 2 | 2006-09-18 08:17 AM |
Linear Mode
