The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

Connectors: choosing where on a shape to attach them Thread Tools Search this Thread Display Modes
Dear All,

I am trying to connect two shapes in a process flow. I want to choose where on a shape the connectors attach themselves to, as the defaults seem to pick the sides of the shapes that are closest to each other.

I am new to Omnigraffle so have no idea whether it is not possible or I just can't find out how to make it happen.

Any tips greatly appreciated.

Thanks, Neil
You can use magnets to determine where a line will connect to a shape; either use the Magnet Tool or the Connections Inspector to place magnets where you'd like.

Hope that helps,
"Vroom! Vroom!!"

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Can I put an OmniPresence folder in my Dropbox folder? [A: Don't do this.] dude OmniPresence 2 2013-05-15 02:00 PM
Choosing an action based on the energy available margauxintegrale OmniFocus 1 for Mac 7 2012-06-19 10:20 AM
Choosing a Localization? captainc OmniFocus for iPhone 10 2009-04-07 01:36 AM
Choosing display for Zoom c-had OmniDazzle 1 2007-08-30 04:53 PM
Choosing between Pro and Regular rmathes OmniGraffle General 10 2007-01-06 09:37 AM

All times are GMT -8. The time now is 07:18 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.