Warping Shapes? - The Omni Group Forums

These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Zoolok

Member

2006-07-17, 09:42 AM

Is it possible?
e.g. If I use the cylinder from the basic stencils thing, can I make it narrower at the bottom than the top?

I suppose I am trying to edit the shape like I would in something like Flash (*exactly* like Flash, if I am totally truthful!)

Thanks

Post 1

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Workflow shapes	zoltanbarabas	OmniGraffle General	3	2013-01-23 11:22 AM
More sophisticated shapes?	jlachoff	OmniGraffle General	5	2011-06-03 05:29 AM
Custom shapes in shapes inspector	sunshine	OmniGraffle General	4	2009-02-27 06:54 AM
3-D Shapes	pbertain	OmniGraffle Extras	1	2008-05-12 02:25 PM

All times are GMT -8. The time now is 08:21 PM.