The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniPlan > OmniPlan General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
start date to show without time Thread Tools Search this Thread Display Modes
is there a way to show the start date as just the date without the time?

cant seem to find a preference for this.
 
We think that time of day may be significant for some projects and not for others, therefore rather than making this a preference, it's a project setting. Look in the Project: Formatting inspector and you'll find the interface for turning on and off the time and seconds.

Note that this only affects the display. Time still exists for these projects. If you want to experiment with the notion that 1 hour or 1 day is the minimum significant time interval in your planning, check out the Granularity setting on the Project: Information inspector.

-Tom
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
start date default time suddenly different flyingdesigner OmniFocus 1 for Mac 0 2013-02-16 10:18 AM
Any way to change date/time format in Start and End columns? jseverino OmniPlan General 1 2013-02-06 03:27 PM
Default Time for Start Date dervid OmniFocus 1 for Mac 15 2012-12-28 10:14 PM
How to show time in the Due Date column? [A: can enable. see thread.] Rockyroad OmniFocus 1 for Mac 13 2012-09-19 07:50 AM
Repeating Tasks... Don't want it to show until start date. adk365 OmniFocus 1 for Mac 4 2008-12-12 09:47 AM


All times are GMT -8. The time now is 08:00 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.