The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

connecting lines to lines Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Using Omnigraffle 3.2.4.

I'm trying to draw two lines that are perpendicular with each other - one horizontal and the other vertical. The horizontal line should terminate at the vertical line somewhere along the vertical line (i.e., NOT at either of the end points of the vertical line).

Everytime I do that, as I get close to the vertical line, the cursor drops below the horizontal line, and I have to include a 90 deg bend in the "horizontal" line and actually place its termination point some small distance "down" the vertical line. (The termination point is actuallly below the starting point.)

How can I just connect a horizontal line to a vertical line without adding this additional segment where the two "lines" actually run parallel?

I'm sorry this must be difficult to follow - I'm new to omnigraffle so there must be something about the fact that the termination point is being connected to the vertical line that is causing the endpoint to move that I don't understand. I don't have a public website on which I could post the file so it would be easier to see what is actually happening.

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Questions about lines connecting objects MrSmith OmniGraffle General 1 2011-09-06 05:38 AM
Connecting lines? fridge OmniGraffle General 3 2008-08-25 09:11 AM
Connecting lines placement Worminger OmniGraffle General 1 2007-02-06 12:41 PM
Connecting lines areiser OmniGraffle General 0 2006-07-27 06:47 AM
connecting lines to lines? st.clair OmniGraffle General 1 2006-04-24 11:12 AM

All times are GMT -8. The time now is 10:48 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2023, vBulletin Solutions, Inc.