I've got my Units & Scale set to pixels, and my grid set to 100 pixels with 10 steps - thus my grid spacing is 10 pixels. Snap to Grid is set to ON.
When I drag a 100x100 pixel rectangle from a stencil, it lands on a non-grid location (E.g., 103, 47.) Is this the intended behavior?
Also, when I finally move an object back onto the grid (e.g., to 500,500), then copy/paste it, I'd expect the pasted object to land on the grid. But no: again, it lands randomly. (In this case, the object copied from an object at 500,500 landed at 493,475.)
This behavior makes the grid really annoying. Is this intended behavior?
When I drag a 100x100 pixel rectangle from a stencil, it lands on a non-grid location (E.g., 103, 47.) Is this the intended behavior?
Also, when I finally move an object back onto the grid (e.g., to 500,500), then copy/paste it, I'd expect the pasted object to land on the grid. But no: again, it lands randomly. (In this case, the object copied from an object at 500,500 landed at 493,475.)
This behavior makes the grid really annoying. Is this intended behavior?
Threaded Mode