The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Arc drawing Thread Tools Search this Thread Display Modes
Is there any way to draw arcs? I need to draw a set of arcs with specific degree measurements.
 
I've been trying to answer the same question, and so far the answer seems to be, "No." I did find this post from Ken Case in the OG mailing list, where he suggests drawing a line, setting the line type to orthogonal, and then adjusting the corner radius until you get the kind of arc you need:

http://www.omnigroup.com/mailman/arc...05/003607.html

Not sure if this addresses your need for specific degree measurements.
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Drawing splines? dave256 OmniGraffle for iPad 5 2012-04-17 01:46 PM
Drawing Parabolas ajrose OmniGraffle General 5 2011-11-11 12:31 AM
No drawing size? billbrietstout OmniGraffle General 3 2010-06-18 12:29 PM
need help drawing an arc amritsari OmniGraffle General 0 2008-01-24 05:20 PM
drawing bugs nivenh OmniWeb General 2 2006-07-20 05:21 PM


All times are GMT -8. The time now is 11:35 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.