The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Orthogonal Line Connectors Thread Tools Search this Thread Display Modes
How can I force an orthogonal line to run from the bottom edge of rectangle 1 to the left edge of rectangle 2? On a 3-section orthogonal line (vertical-horontal-vertical : I can only grab the horizontal segment and move it up/down). Can I also move the end points or 2 end segments?
 
You can put some magnets on your shapes using the Magnet Tool or the Connections Inspector and the line should snap nicely to the magnets.
__________________
"Vroom! Vroom!!"
 
Thanks, that works brilliantly !
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Automatic layout works poorly with orthogonal connectors RobTrew OmniGraffle General 13 2013-05-02 09:53 PM
Help With Line Connectors... Marty_Rush OmniGraffle General 0 2013-01-19 07:19 PM
Orthogonal Line Routing mlpotgieter OmniGraffle General 6 2011-05-16 01:31 PM
problem about orthogonal connected line routine_work OmniGraffle General 2 2009-01-27 02:00 AM
orthogonal line problems tah OmniGraffle General 0 2007-12-03 05:19 PM


All times are GMT -8. The time now is 01:39 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.