The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

Orthogonal Line Connectors Thread Tools Search this Thread Display Modes
How can I force an orthogonal line to run from the bottom edge of rectangle 1 to the left edge of rectangle 2? On a 3-section orthogonal line (vertical-horontal-vertical : I can only grab the horizontal segment and move it up/down). Can I also move the end points or 2 end segments?
You can put some magnets on your shapes using the Magnet Tool or the Connections Inspector and the line should snap nicely to the magnets.
"Vroom! Vroom!!"
Thanks, that works brilliantly !

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Automatic layout works poorly with orthogonal connectors RobTrew OmniGraffle General 13 2013-05-02 09:53 PM
Help With Line Connectors... Marty_Rush OmniGraffle General 0 2013-01-19 07:19 PM
Orthogonal Line Routing mlpotgieter OmniGraffle General 6 2011-05-16 01:31 PM
problem about orthogonal connected line routine_work OmniGraffle General 2 2009-01-27 02:00 AM
orthogonal line problems tah OmniGraffle General 0 2007-12-03 05:19 PM

All times are GMT -8. The time now is 04:17 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.