The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
tangential connectors Thread Tools Search this Thread Display Modes
I'm trying to draw a 'blow up' of a part of a drawing by putting a circle around the area in the original drawing, with a larger circle showing the detail off to the side. I'd like to draw a couple of connectors that are tangential to the two circles (and stop on the edge of each). Is there an easy way to do this or do I have to add magnets to each and then manually move them if I move the circles relative to each other?

tia
Tim
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Crooked connectors CVN OmniGraffle for iPad 7 2013-03-26 01:02 AM
Help With Line Connectors... Marty_Rush OmniGraffle General 0 2013-01-19 07:19 PM
connectors mess synthview OmniGraffle General 0 2011-09-07 06:17 AM
Orthogonal Line Connectors Sophie OmniGraffle General 2 2009-03-14 03:36 PM
Connectors Problem gigamike OmniGraffle General 1 2006-08-01 11:10 PM


All times are GMT -8. The time now is 03:28 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.