The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Multiple Lines Connecting Objects Thread Tools Search this Thread Display Modes
When multiple lines connect between two objects and "Layout Entire Canvas" is selected the lines end up on top of each other.

Is there any way to make sure that lines between the same two objects do not cover each other up?
 
You can put some magnets on your shapes using either the Magnet Tool or the Connections Inspector, and then connect the lines directly to the magnets as opposed to simply snapping to the nearest one, that should work.

Hope that helps,
__________________
"Vroom! Vroom!!"
 
Thanks, I'll try that.
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Objects moving around when connecting them with lines Imme2011 OmniGraffle General 2 2012-04-11 08:04 AM
Questions about lines connecting objects MrSmith OmniGraffle General 1 2011-09-06 06:38 AM
Connecting objects between shared layers drzow OmniGraffle General 2 2009-09-03 07:40 AM
Connecting lines? fridge OmniGraffle General 3 2008-08-25 10:11 AM
Connecting lines areiser OmniGraffle General 0 2006-07-27 07:47 AM


All times are GMT -8. The time now is 10:07 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.