The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Laying out an organizational chart Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
I'm having problems here. I want to fit the chart onto a single sheet of paper. It's quite wide so even in landscape mode the boxes need quite a lot of organization to fit everything in. If I leave it to OmniGraffle to do it then when the boxes at level 3 extend towards the right hand edge, the connectors from level 2 get tangled up. If I pull the boxes around manually, then the next time I add a box or try to get OmniGraffle to tidy things up, it makes the most incredible spaghetti – total nonsense. Help!
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Best way to test new organizational approach? [A: Make backup; revert if needed.] kray OmniFocus 1 for Mac 1 2011-02-08 03:56 PM
Can you generate an Org Chart? Jack71 OmniGraffle General 0 2009-10-22 03:13 AM
Round Chart robinmeijerink@mac.com OmniGraffle General 2 2007-09-19 02:03 PM


All times are GMT -8. The time now is 12:05 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.