The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Line tool and rotations Thread Tools Search this Thread Display Modes
Sometimes when I draw a line with the line tool, the Geometry Inspector shows that the line is at a funny angle (310.6 degrees right now) even though the line is horizontal. Where's this setting coming from, and how can I reset it so that horizontal lines are at an angle of 0 degrees (or some other sensible value)?
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Timeline tool dfclark OmniGraffle Extras 14 2013-03-22 12:28 PM
Odd behavior - line tool rearrances shapes? [A: template with auto-layout enabled was chosen] erickhill OmniPlan General 2 2012-06-27 03:02 PM
Crop tool MatthewS OmniGraffle General 1 2012-06-21 08:17 AM
Round line ends not centered on end of line billbrietstout OmniGraffle General 3 2012-05-17 09:08 AM
Is OmniPlan the tool I need? sriggins OmniPlan General 2 2007-10-08 04:29 PM


All times are GMT -8. The time now is 02:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2022, vBulletin Solutions, Inc.