How do I save printer settings in Omniplan.
I have a chart where I want smaller margins than the default.
If I do cmd-P, one of the pull-down menus brings me to an omniplan environment where I can adjust the margins. This works fine. However,
when I then exit the program and start again, the margins are back to
the default.
I've tried to do save-as in the presets pull down menu. This creates an entry, but it doesn't save the new margins.
Henk
I have a chart where I want smaller margins than the default.
If I do cmd-P, one of the pull-down menus brings me to an omniplan environment where I can adjust the margins. This works fine. However,
when I then exit the program and start again, the margins are back to
the default.
I've tried to do save-as in the presets pull down menu. This creates an entry, but it doesn't save the new margins.
Henk