Hi,
Just purchased OmniPlan for iPad v1.2, and I have OmniOutliner for iPad v1.4.3. Is the following a bug or an unimplemented feature?
1. Select a document and tap Share in OmniOutliner
2. Select Send to App and pick OO format document
3. The option to Open in OmniPlan is offered (good, that is as it should be as sketching out your project can be quicker in OO than OP)
4. Select the choice and OmniPlan opens and presents the following error:
If a bug, is there a timescale on when it'll be fixed. If an unimplemented feature is it one that is due to come in the future?
TIA
Edit: Similarly, sharing from OmniPlan back to OmniOutliner or OmniGraffle fails with the same error message.
Just purchased OmniPlan for iPad v1.2, and I have OmniOutliner for iPad v1.4.3. Is the following a bug or an unimplemented feature?
1. Select a document and tap Share in OmniOutliner
2. Select Send to App and pick OO format document
3. The option to Open in OmniPlan is offered (good, that is as it should be as sketching out your project can be quicker in OO than OP)
4. Select the choice and OmniPlan opens and presents the following error:
Unable to open file.
OmniPlan cannot open this type of file.
Cancel
OmniPlan cannot open this type of file.
Cancel
If a bug, is there a timescale on when it'll be fixed. If an unimplemented feature is it one that is due to come in the future?
TIA
Edit: Similarly, sharing from OmniPlan back to OmniOutliner or OmniGraffle fails with the same error message.
Last edited by JKT; 2013-05-12 at 07:26 AM..