The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
Disappearance of angle handles on arc shape Thread Tools Search this Thread Display Modes
When I use an arc shape and click on the handles at the end of the arc to change the arc angle, I notice that the handles disappear when the angle is a multiple of 90 degrees. They are covered by the resize handles. Is there any way to get them back?

Thanks.

Warren Nagourney
 
You can click through the selection handles with Option-Command.

HTH
__________________
"Vroom! Vroom!!"
 
Thanks very much, that worked fine.

wn
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Measure angle gpano OmniGraffle General 0 2013-03-28 05:43 PM
Measuring length and angle of lines? bouvin OmniGraffle General 1 2008-12-14 12:01 PM
Graphviz support for right-angle connectors ? RobTrew OmniGraffle General 2 2008-10-15 07:11 AM
Creating and Editing Right Angle Lines ssipiora OmniGraffle General 1 2008-09-30 10:26 AM
Controlling angle of lines into magnets... how? glawrie OmniGraffle General 3 2006-06-23 03:27 PM


All times are GMT -8. The time now is 12:43 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.