The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

tangential connectors Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
I'm trying to draw a 'blow up' of a part of a drawing by putting a circle around the area in the original drawing, with a larger circle showing the detail off to the side. I'd like to draw a couple of connectors that are tangential to the two circles (and stop on the edge of each). Is there an easy way to do this or do I have to add magnets to each and then manually move them if I move the circles relative to each other?


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Crooked connectors CVN OmniGraffle for iPad 7 2013-03-26 02:02 AM
Help With Line Connectors... Marty_Rush OmniGraffle General 0 2013-01-19 08:19 PM
connectors mess synthview OmniGraffle General 0 2011-09-07 07:17 AM
Orthogonal Line Connectors Sophie OmniGraffle General 2 2009-03-14 04:36 PM
Connectors Problem gigamike OmniGraffle General 1 2006-08-02 12:10 AM

All times are GMT -8. The time now is 09:03 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2023, vBulletin Solutions, Inc.