The Omni Group
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!

Go Back   The Omni Group Forums > OmniGraffle > OmniGraffle General
FAQ Members List Calendar Search Today's Posts Mark Forums Read

 
How do you set line length? Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
I finally figured out how to show line length by searching the forum <%length%>. I am drawing a pair of brackets with holes a specific spacing apart. Easy enough in Visio, a real challenge in Omnigraffle. In Visio I can set a specific line length, and drag the center of a circle directly on the end of the line. In Omnigraffle I can't seem to set the length of a line, or drag a circle center onto the end of a line. This also makes it difficult to set measurement lines.

How do you set line length?
 
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Beginner's question about line length pyrogerg OmniGraffle General 1 2012-05-01 01:08 PM
Line length increments nestorph OmniGraffle General 0 2011-07-09 02:50 PM
Display line length? 5DollarShake OmniGraffle General 2 2010-07-28 10:56 AM
Maximum Note Length? SurfKauai43 OmniFocus 1 for Mac 0 2008-12-30 09:58 AM
Line length questions Gabe OmniGraffle General 0 2008-03-22 10:22 AM


All times are GMT -8. The time now is 05:53 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.