 |
|
These forums are now read-only. Please visit our new forums to participate in discussion. A new account will be required to post in the new forums. For more info on the switch, see this post. Thank you!
|
|
Member
2007-01-31, 11:07 AM
I just got a dialog saying 5.5.4b1 is available, but clicking "more info" gives me the 5.5.3 page.
Post 1
|
|
Member
2007-01-31, 11:30 AM
Yep, same here.
Post 2
|
|
Member
2007-01-31, 11:31 AM
Well, same here
Post 3
|
|
Member
2007-01-31, 12:14 PM
Ditto again. I did notice the pdf manual on the download page. Is that new?
Payam
Post 4
|
|
Omni Test Pilot
2007-01-31, 12:25 PM
Uh sorry guys, there was an early misfire, this afternoon, promise :)
Post 5
|
|
Omni Test Pilot
2007-01-31, 01:34 PM
Okay should be up now!
Post 6
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Got Beta? | kmp | OmniOutliner 3 for Mac | 2 | 2008-08-12 09:33 AM |
| Beta 9 is available! | skwirl | OmniPlan General | 0 | 2006-11-08 03:26 PM |
| Beta 8 is available | Lizard | OmniPlan General | 6 | 2006-10-20 08:53 AM |
| Beta 7 is available | Lizard | OmniPlan General | 0 | 2006-09-27 02:34 PM |
| beta 6 expires on September 13th -- get beta 6b | smhaunch | OmniPlan General | 1 | 2006-09-12 12:39 PM |
Linear Mode
